|
In
Novell's use of RIP, there are two metrics used to make routing
decisions. Select the two metrics.
A. Ticks.
B. Hops
C. Loops
D. Counts
Ans:A
&B
It first
uses ticks (which is about 1/18 sec.); if there is a tie, it
uses hops; if hops are equal, then it uses an administratively
assigned tiebreaker.
What is
the Cisco name for the encapsulation type used on a serial
interface?
A. HDLC
B. SDLC
C. SAP
D. SNAP
Ans A
"arpa" is
used by the Cisco IOS for which encapsulation types?
A.
Ethernet_II
B.
Ethernet_802.3
C.
Ethernet_802.2
D.
Ethernet_SNAP
Ans A
Novell's IPX
and Cisco's IOS name their protocols differently. Cisco uses sap
for Ethernet_802.2, Token-Ring, and Novell's FDDI_802.2. Cisco
uses snap for Ethernet_SNAP, Token-Ring_SNAP, and FDDI_SNAP.
Cisco uses arpa for Ethernet_II and, finally the default is
Novell-ether for Novell's Ethernet_802.3.
"snap" is
used by the Cisco IOS for which encapsulation types?
A. Ethernet_SNAP
B. Token-Ring_SNAP
C. FDDI_SNAP
D. Novell-SNAP
E. Novell-FDDI.
Ans:
A,B &C Novell's IPX and Cisco's IOS name their protocols
differently. Cisco uses sap for Ethernet_802.2, Token-Ring, and
Novell's FDDI_802.2. Cisco uses snap for Ethernet_SNAP, Token-Ring_SNAP,
and FDDI_SNAP. Cisco uses arpa for Ethernet_II and, finally the
default is Novell-ether for Novell's Ethernet_802.3.
As system
administrator, you type "debug ipx sap" and receive the
following lines as part of the IOS response: type 0x4, "HELLO2",
199.0002.0003.0006 (451), 2 hops type 0x4, "HELLO1",
199.0002.0003.0008 (451), 2 hops What does "0x4" signify?
-
A. That
is a Get Nearest Server response.
-
B. That
it is a General query.
-
C. That
it is a General response.
-
D. That
it is a Get Nearest Server request.
Ans A
To monitor
IP igrp traffic, you can use "debug IP igrp transaction" or
"debug IP igrp events". How do you display information about IPX
routing update packets?
To monitor
ipx traffic on a network, what command would you use?
-
A. debug
ipx transaction
-
B. show
ipx traffic
-
C. show
ipx events
-
D.
display ipx traffic
Ans B
What
command would you use to find out the names of Novell servers on
a network?
-
A. show
ipx servers
-
B. show
ipx hosts
-
C. show
ipx sap
-
D. show
ipx nodes.
Ans A
|
