Computer Tutorials
Earn Money From Internet
Cheap Freelancers
Ask An Expert
Register Cheap Domain
Data Recovery
Best Mutual Funds
Trading Forex Online
Cheap Web Hosting
Ajax Tutorials
Cheap Cell Phone Plans
Free Mobile Learning
Job Portal
Photoshop Tutorials
Cheap Jewelry
Cheapest Air Travel
Answer: C
The clock rate command (two words), is used to provide clocking on a line where no DCE device is located.
Chapter: 7
306. Which of the following statements regarding routed and routing protocols are true?
(Select 2 choices)
A. A routed protocol is assigned to an interface and determines the method of packet delivery B. A routing protocol determines the path of the packet through a network C. A routed protocol determines the path of the packet through a network D. A routing protocol operates at the transport layer of the OSI model E. A routed protocol updates the routing table of a router Answer: A, B Routed protocols (example, IP and IPX) is used to provide logical network address and provides framing of a
packet on a LAN.
Routing protocols (example RIP and OSPF) are used to determine the path of a packet through the network by updating the routing table on a router.
Chapter: 7
307. When powering up a router, which of the following types of memory normally stores the start-up configuration?
A. RAM B. ROM
C. FLASH
D. NVRAM
Answer: D
The startup-config, if placed there by an administrator, is stored in the Non-Volatile RAM.
Chapter: 7
308. Based on the debug output shown, what type of handshake occurred for PPP authentication?
#debug ppp authentication
ppp serial1: Send CHAP challenge id=34 to remote ppp serial1: CHAP challenge from P1R2
ppp serial1: CHAP response received from P1R2
ppp serial1: CHAP response id=34 received from P1R2 ppp serial1: Send CHAP success id=34 to remote
ppp serial1: Remote passed CHAP authentication