Computer Tutorials
Earn Money From Internet
Cheap Freelancers
Ask An Expert
Register Cheap Domain
Data Recovery
Best Mutual Funds
Trading Forex Online
Cheap Web Hosting
Ajax Tutorials
Cheap Cell Phone Plans
Free Mobile Learning
Job Portal
Photoshop Tutorials
Cheap Jewelry
Cheapest Air Travel
272. When you configure an IP address on a Cisco router, which command starts the IP processing on the
interface?
A. The No Shutdown command
B. The Exit command C. The IP processing on the interface is started by default
D. When pressing the Enter key after the IP address assignment.
Answer: D
The IP processing on the interface is started as soon as you press the enter key to complete the IP address assignment.
Chapter: 6
273. What are the commands that can be used to configure information into RAM on a router?
A. Config Terminal
B. Config Memory C. Config Net
D. All of the above
Answer: D
All three commands will configure information into RAM. The difference is where the information originates (Terminal from RAM, Memory from NVRAM and Net from a TFTP server.)
Chapter: 6
274. Write the command to set the clock rate to 56kbps on serial 0 A. Clock rate 56kbps
B. Clock rate 56
C. Clock rate 56000 D. Clock rate 56000000
Answer: C
The clock rate for a serial interface must be enter at the interface configuration mode and must specific one of the accepted clock rates. To see all accepted rates on the interface enter clock rate ?
.
Chapter: 6
275. What two solutions are used to reduce the chance of distance vector routing loops?
A. Route Poisoning and Distance Vectors