Computer Tutorials
Earn Money From Internet
Cheap Freelancers
Ask An Expert
Register Cheap Domain
Data Recovery
Best Mutual Funds
Trading Forex Online
Cheap Web Hosting
Ajax Tutorials
Cheap Cell Phone Plans
Free Mobile Learning
Job Portal
Photoshop Tutorials
Cheap Jewelry
Cheapest Air Travel
252. What command will change the CDP timer?
A. router(config)#cdp timer B. router#cdp timer
C. router(config-router)#cdp timer
D. router(config-if)#cdp timer
Answer: A
At the global configuration mode you may adjust the CDP timer interval.
Chapter: 6
253. What is the default CDP timer set to?
A. 60
B. 90 C. 180
D. 240
Answer: A
The CDP timer is used to tell the router when to broadcast CDP infromation. By default, all Cisco routers send this infromation out all active interfaces every 60 seconds.
Chapter: 6
254. Which command sets the clock rate to 56Kbps on serial 0?
A. clockrate 56kbps B. clockrate 56 C. clock rate 56000 D. clock rate 56000000 Answer: C
The clock rate for a serial interface must be entered at the interface configuration mode and must specify one of the accepted clock rates. To see all accepted rates on the interface, enter clock rate ?
. Remember that this command is two words: clock rate <setting>.
Chapter: 6