Computer Tutorials
Earn Money From Internet
Cheap Freelancers
Ask An Expert
Register Cheap Domain
Data Recovery
Best Mutual Funds
Trading Forex Online
Cheap Web Hosting
Ajax Tutorials
Cheap Cell Phone Plans
Free Mobile Learning
Job Portal
Photoshop Tutorials
Cheap Jewelry
Cheapest Air Travel
use a Telnet session to check for a network address parameter. Your Telnet login and your virtual terminal session on the other device are successful.
What is the default that you must enter to suspend your Telnet session and return to the original router?
A. suspend
B. the command exit C. Ctrl-Esc follow by x
D. Ctrl-alt-delete followed by Esc
E. Ctrl-Shift-6 together followed by x
Answer: E
To suspend any Telnet session you enter Ctrl-Shift-6 together then x.
Chapter: 3
150. Which of the following messages displays the code image running in router memory?
A. System Bootstrap, Version 12.1(3r)T2, RELEASE SOFTWARE (fc1)Copyright (c) 2000 by cisco Systems,
Inc.C2600 platform with 32768 Kbytes of main memory B. program load complete, entry point: 0x80008000, size: 0x43b7fC. Self decompressing the image:
######################################################################################
###############################################[OK] C. Cisco Internetwork Operating System Software IOS (tm) C2600 Software (C2600-I-M), Version 12.1(8),
RELEASE SOFTWARE (fc1)Copyright (c) 1986-2001 by cisco Systems, Inc.Compiled Tue 17-Apr-01 04:55
by kellythw Image text-base: 0x80008088, data-base: 0x8080853C D. cisco 2621 (MPC860) processor (revision 0x101) with 26624K/6144K bytes of memory. Processor board
ID JAD050697JB (146699779)M860 processor: part number 0, mask 49 Bridging software. X.25 software, Version 3.0.0.2 FastEthernet/IEEE 802.3 interface(s)1 Serial network interface(s) 32K bytes of non-volatile
configuration memory. 8192K bytes of processor board System flash (Read/Write)
Answer: C
Although there is a lot of information displayed during the startup only the area labeled C has the code image name.
Chapter: 3
151. What are the two ways that you can enter setup mode on a router?
A. By typing the clear flash command B. By typing the erase start command and rebooting the router
C. By typing the setup command
D. By typing the setup mode command Answer: B, C
If there is no configuration the router will automatically start the setup process. You can enter that process at
any time by typing in setup and pressing enter.
Chapter: 4