Computer Tutorials
Earn Money From Internet
Cheap Freelancers
Ask An Expert
Register Cheap Domain
Data Recovery
Best Mutual Funds
Trading Forex Online
Cheap Web Hosting
Ajax Tutorials
Cheap Cell Phone Plans
Free Mobile Learning
Job Portal
Photoshop Tutorials
Cheap Jewelry
Cheapest Air Travel
C 192.168.50.0/24 is directly connected, Ethernet0 A. 172.16.30.0
B. 192.168.30.0
C. 10.0.0.0 D. All of them will be placed in the neighbors routing table Answer: C
The network 10.0.0.0 cannot be placed in the next routers routing table because it already is at 15 hops. One more hop would make the route 16 hops, and that is not valid in RIP networking.
Chapter: 2
94. Which of the following are valid frame relay terms?
A. X.25
B. DLCI C. PAP
D. LMI
Answer: B, D Data Link connection Identifier and Local Management Interface are valid Frame Relay terms.
Chapter: 2
95. What is the frame relay map command used for?
A. To identify the hardware address of the local interface
B. To identify the virtual circuit C. Map a DLCI address to an IP address
D. Route packets in the Frame PVC
Answer: C
The Frame Relay map command tells the network how to get from a specific IP address to the correct local data link connection identifier (DLCI).
Chapter: 2
96. When configuring Frame Relay, which parameters are true for creating serial subinterfaces?
A. config t, int s0.100, ipx network 100 encap sap
B. config t, int s0.100, ipx network 100 encap arpa C. config t, int s0.100, ipx network 100
D. config t, int s0.100, ipx network 100 encap hdlc
Answer: C