Computer Tutorials
Earn Money From Internet
Cheap Freelancers
Ask An Expert
Register Cheap Domain
Data Recovery
Best Mutual Funds
Trading Forex Online
Cheap Web Hosting
Ajax Tutorials
Cheap Cell Phone Plans
Free Mobile Learning
Job Portal
Photoshop Tutorials
Cheap Jewelry
Cheapest Air Travel
EIGRP uses D, RIP uses R, S identifies a static route, and I indicates IGRP.
Chapter: 2
91. A router chooses the OSPF Router ID based on which of the following?
A. Lowest IP address from any interface B. Highest IP address from any interface C. Lowest IP address from any loopback interface D. Highest IP address from any loopback interface Answer: D
The Router ID is determined by the highest IP address configured on a loopback interface. If a router does not have a loopback interface, then the Router ID is determined by the highest IP address configured on the
router.
Chapter: 2
92. In the following routing table, what does the [120/3] mean?
R 192.168.30.0/24 [120/1] via 192.168.40.1, 00:00:23, Serial0/0
C 192.168.40.0/24 is directly connected, Serial0/0 R 192.168.20.0/24 [120/1] via 192.168.40.1, 00:00:23, Serial/0
R 10.0.0.0/8 [120/2] via 192.168.40.1, 00:00:23, Serial0/0
C 192.168.50.0/24 is directly connected, FastEthernet0 R 192.168.3.0/24 [120/3] via 192.168.40.1, 00:00:23, Serial0/0
A. The IP port number and packets sent B. The administrative distance and metric C. The metric and hop count D. The bandwidth and update timer The [120/3] is administrative distance and hop count (metric)
Answer: B
Chapter: 2
93. You have the following routing table. Which of the following networks will not be placed in the neighbor
routing table? R 192.168.30.0/24 [120/1] via 192.168.40.1, 00:00:12, Serial0
C 192.168.40.0/24 is directly connected, Serial0
172.16.0.0/24 is subnetted, 1 subnets C 172.16.30.0 is directly connected, Loopback0
R 192.168.20.0/24 [120/1] via 192.168.40.1, 00:00:12, Serial0