Computer Tutorials
Earn Money From Internet
Cheap Freelancers
Ask An Expert
Register Cheap Domain
Data Recovery
Best Mutual Funds
Trading Forex Online
Cheap Web Hosting
Ajax Tutorials
Cheap Cell Phone Plans
Free Mobile Learning
Job Portal
Photoshop Tutorials
Cheap Jewelry
Cheapest Air Travel
58. What command will put you into setup mode after restarting the router? (choose 2)
A. Restart B. Setup
C. Boot system
D. erase star E. wr erase
Answer: D, E
The command Setup, run from privileged mode, will immediately put you into setup mode. Erase star and write erase will erase the startup-config and put you into setup mode when the router is reloaded.
Chapter: 2
59. When in setup mode, which of the following is true?
A. The ip address and subnet mask must be entered on the same line
B. The ip address and mask are assigned on separate lines C. You can configure AppleTalk routing
D. You are prompted to set the enable secret, secret, console and VTY passwords
Answer: B, C When in setup mode, the IP address and subnet mask are defined on separate lines. You can also configure
multiple protocols if the IOS software supports it. Also, you are prompted to set the enable secret, secret and
VTY passwords only. You must set the console and Aux passwords after setup.
Chapter: 2
60. When in setup mode, what happens if you do not set the VTY password?
A. You won't be able to logon from the console port
B. You won't be able to logon from the aux port
C. You won't be able to telnet into the router D. Nothing
Answer: C
If you do not set the VTY password, you will be denied access when trying to telnet into the router. You can set this during setup or at anytime after you finish configuring your router.
Chapter: 2
61. How do you create a backup of the Cisco IOS and store it on a TFTP server?
A. copy backup to tftp
B. copy run to tftp